|
Please Check
Here for frequent code changes
How to change your code for Digiwave Receivers 1)
Press MENU, Scroll down to USER INSTALLATION, Scroll down to SYSTEM
SETTING, press OK. 2) Press red buton (audio) on the remote 3) Press
right arrow until NAGRA2 (NOT NAGRA) appears in the first line. 4)
Down to next line to PROVIDER and use right arrow to go to 0001
DISHNETWORK. 5) Now scroll down to Key00 or Key01 and press OK. 6)
Enter new code 7) After finish, scroll down and SAVE KEY. Press EXIT,
EXIT, and EXIT again. 8) Enjoy TV
PANSAT
2300A/2500A/2700A; PANTEC;
SMARTWAVE;
EAGLESTAR; FANSAT; ARIZA700
|
->Press
"Menu" on remote
->Go down to " Parental Control" & Click
"OK" on remote
->Go down to "Second Pin" & Press
"0000" in your remote, and you can go into "CAS
SYSTEM" menu,
If your STB is Ariza 700, just press"i2004"
in your remote;
->Go down to "Nagravision" & select
"OK" on remote
->Using the arrow keys on your remote(volume up) scroll until
you see "Dish Network"
->Go down to "Key number" & using the
"volume up key" press twice, you will now notice on the
top left
corner of the screen "Negravision2" and your
"Key number" should be "00"
->Using your remote, channel down button, select "Key
data" on the menu & enter the new keys for key 00.
Then press "OK" on remote to store(the
button "ok/store" will flash)
->Go back to "Key number" on menu & press
"Volume up" once on remote (it will be "01").
Make sure on your
top left hand corner of the screen is still "
Negravision2"
->Using your remote, channel down button, select "Key
data" on the menu & enter the new keys for key 01.
Then press "OK" on remote to store(the
button "ok/store" will flash)
->Press "EXIT" on remote, Go down to "Key
EMU", press "right" button or "Volume"
button to make "Key EMU" is "ON"
->Press "exit, exit, exit" and enjoy!
|
How
to Upgrade From Computer to Receiver-DG6800, DG7000
Downloading Procedure for Digiwave DG6800/DG7000 Receiver
1. Connect satellite receiver to PC with RS-232C null modem cable.
2. Turn on the power of the satellite receiver
3. After upgrade software, open the Downloading Program.
4. Click OK
5. Waiting for the receiver said GOOD
6. Shutdown the power for receiver and turn on
7. You can using your receiver now
**** Do not interrupt the downloading until it complete *****
Note: Use regular RS-232C Null modem cable for downloading PC to
Receiver.
Use RS-232 DB-9 Null modem cable for data transfer between Receivers
To Receiver
Upgrade Cable
 Note:
For software transfer from PC--Receiver or from Receiver--Receiver, use
our RS-232 Null Modem Cable.
RS-232 Used for PC--Receiver & Receiver--Receiver Software Transfer.
This is the cable wire that you use along with all MRX-receivers. This
is a null modem cable.
|
